Instructions

ADAM-6000 User Manual 54
Figure 6.4 Adam/Apax .NET Utility - Searching for Devices
You need to change the IP address of the ADAM-6000 module so that it is the same
subnet as the host PC. Enter the correct IP address, subnet address, and default
gateway on the Status Display Area and then click Apply Change. A dialog box will
appear asking you to enter the password. The default password of ADAM-6000 mod-
ules is "00000000" (without quotation marks). After you have entered the correct
password, the ADAM-6000 module will be under IP of your host PC. Note that you
can change the password later.
When you select the IP address of the ADAM-6000 modules you want use in Module
Tree Display Area, eight tabs will become available in the Status Display Area. These
tabs are for the general configuration of that module. Once you have changed any
settings, remember to click Apply or Apply Change. These eight tabs are detailed in
the following sections.
Note! If a network firewall is enabled, you might not be able to connect to your
ADAM-6000 module. You may need to add an exception for Adam/Apax
.NET Utility in Windows Firewall via Windows Control Panel.