Instructions

139 ADAM-6000 User Manual
Chapter 7 Planning Your Application Program
Configuration Using Adam/Apax .NET Utility
The host IP where SNMP trap messages are sent to can be configured using Adam/
Apax .NET Utility V2.05.10 (B04) or later. Follow these steps to do so:
1. From the Module Tree Display Area, select the module you wish to configure
2. Click the Stream/Trap tab in the Status Display Area and then click the SNMP
Trap tab
3. Ensure that the trap function is disabled (clear the check box beside the host IP)
4. Enter the host IP and click Apply
5. Enable the trap function (select the check box beside the host IP)
6. Set the deadband value and click Apply change
Figure 7.3 Trap Configuration Using Adam/Apax .NET Utility
Specific Type Channel Description
131 0
Analog Input High Alarm
132 1
133 2
134 3
135 4
136 5
137 6
138 7
141 0
Analog Input Low Alarm
142 1
143 2
144 3
145 4
146 5
147 6
148 7