User Manual

ADAM-6000 Series User Manual 62
Then ADAM-6000 modules will periodically send its I/O status to
the Host. The IP and period to transfer data is configured in the
Stream tab of Status Display area. The configuration tab will be
introduced in Section 5.3.2.
7. Monitor Peer-to-Peer - ADAM-6000 modules with Peer-to-Peer
function can play as Event Trigger function. Refer to Section 5.3.5
for more information. You can choose this option to receive mes-
sage from ADAM-6000 module which is enabled Peer-to-Peer
(Event Trigger) function.
8. Monitor GCL IO Data Message - ADAM-6000 modules with GCL
function can play as a standalone controller. Users can define logic
rules and run the rules on ADAM-6000 module. User can define
the logic rule to send out message, depending on the logic condi-
tion, to the Host defined by IP. Refer to Chapter 7 for more infor-
mation about GCL. You can choose this option to receive I/O data
message from ADAM-6000 module which is enabled GCL func-
tion.
Note: When you enable GCL function, Data Stream function will
automatically be disabled until you disable GLC function.