User Manual

43 Chapter 4

Assigning Addresses in ADAM-6050 Modules

Basing on Modbus/TCP standard, the addresses of the I/O channels in

ADAM-6000 modules you place in the system are defined by a simple

rule. Please refer to Appendix B.2.5 to map the I/O address. All digital

input channels in ADAM-6050 are allowed to use as 32-bit counters

(Each counter is consisted of two addresses, Low word and High word).

Users could configure the specific DI channels to be counters via Win-

dows Utility. (Refer to Section 5.3)

4.2.2 ADAM-6051

14-ch Isolated Digital Input/Output with 2-ch Counter Module

The ADAM-6051 is a high-density I/O module built-in a 10/100 based-T

interface for seamless Ethernet connectivity. It provides 12 digital input,

2 digital output, and 2 counter channels with 2000 V

isolation protec-

tion. All of the digital input channels support input latch function for

important signal handling. Meanwhile, these DI channels allow to be

used as 3 kHz counter and frequency input channels. Opposite to the

intelligent DI functions, the digital output channels also support pulse

output function.

ADAM-6051 Specifications

• Communication: 10/100 Base-T Ethernet

• Supports Protocol: Modbus/TCP, TCP/IP, UDP, HTTP, ICMP, DHCP

and ARP

• Supports Peer-to-Peer and GCL (Refer to Section 5.3.5 and Chapter 7)

Digital Input

• Channels: 12

• Dry Contact:

Logic level 0: Close to GND

Logic level 1: Open

• Wet Contact:

Logic level 0: 0 ~ 3 V

Logic level 1: 10 ~ 30 V

• Supports 3 kHz counter input (32-bit + 1-bit overflow)

• Supports 3 kHz frequency input

• Supports inverted DI status