User Manual

ADAM-6000 Series User Manual 104
tal input channel value changes, the data will also update from source to
destination automatically.
By default, all input channels of the source module will all be mapping to
all output channels of the destination module. However, you can manu-
ally define which input channels are mapping to output channels, by
clicking the Modify channel enable check box. When this check box is
checked, you can select which input channels will be mapping to the cor-
responding output channels by click related Channel check box. Refer to
Figure 5.22 below. In this example, only the value of input channels 0, 1,
2, 3 of the source module will update to the output channels 0, 1, 2, 3 of
the destination module. After you have selected the channel, click the
Apply list button to download this configuration to the source module.
You can save current mapping relation into a configuration file in your
computer by clicking the Save button. You also can load previous map-
ping configuration file by clicking the Load button. If you click the
Refresh button, the current mapping configuration on the source module
will be displayed in the Channel-Enable table. (The area enclosed by the
red square in Figure 5.22)
Figure 5.22: Building the Mapping Relationship
• Advanced Mode Configuration