User Manual

103 Chapter 5
• Basic Mode Configuration
When you choose the basic mode, the Status Display should look like the
Figure 5.21 below. You can define the target device by entering its IP
address into the Destination text box in the Basic (One to One) area.
Figure 5.21: Peer-to-Peer Basic Mode Configuration
We have mentioned that there are two methods to transfer data from the
ADAM-6000 (source) to the target device (destination): Period Time
function or Period Time function + C.O.S. function. You can choose
these two methods by click the Deviation Enable check box (for AI
modules) or Enable Change of State check box (for digital modules).
If this check box is not checked, the transfer method is Period Time
function. The period to transfer data from source to destination is defined
by the Period time numeric control in the Basic (One to One) area.
If the check box is checked, the transfer method becomes Period Time
function + C.O.S. function. You can define the deviation for analog
input by the Deviation Rate numeric control (value is percentage unit
and represent the change value divided by the total range).
For Period Time function + C.O.S function, the data will be transferred
from source to destination periodically. Besides, when the analog input
value change is greater than what the Deviation Rate defined or the digi-