User Manual

ADAM-6000 Series User Manual 102
• How to configure Peer-to-Peer functions
As we have mentioned in section 5.3.2, when you select the IP address of
the ADAM-6000 modules you want use in Module Tree Display area,
there will be 8 tabs appearing in the Status Display area for you to set up
general configurations of that module. You can configure all Peer-to-Peer
function setting in the Peer-to-Peer/Event tab. Refer to Figure 5-20
below to see the image when you choose the Peer-to-Peer/Event tab.
Figure 5.20: Peer-to-Peer Configuration Tab
The Peer-to-Peer function is disabled by default. You can enable it and
choose the basic mode or advanced mode by click the Basic or Advanced
radio button in the Mode area. After you choose the mode, click the
Apply button. ADAM-6000 modules features Peer-to-Peer and GCL
function in the same hardware. (The GCL feature will be introduced in
Chapter 7) However, only one of them can be enabled at one time. If you
have enabled GCL function before and now choose to enable Peer-to-
Peer function, there will be one warning message asking you to disable
GCL function first. (Refer to section 7.2 for how to disable GCL). After
GCL function is disable, you can select Basic or Advanced mode for
Peer-to-Peer function.