User Manual

5 Chapter 1
1.2.7 Modbus/TCP Software Support
The ADAM-6000s firmware has a built-in Modbus/TCP server. Advan-
tech provides the ADAM.NET Class Library and Windows ADAM.NET
Utility for users. Users can configure this DA&C system via Windows
Utility; integrate with HMI software package via Modbus/TCP driver.
Users can also purchase Advantech OPC server to operate Modbus/TCP.
1.3 Specifications
Ethernet: 10/100 Base-T
Wiring: UTP, category 5 or greater
Bus Connection: RJ45 modular jack
Comm. Protocol: Modbus/TCP on TCP/IP and UDP
Data Transfer Rate: Up to 100 Mbps
Unregulated 10 to 30 VDC
Status Indicator: Power, CPU, Communication
(Link, Collide, 10/100 Mbps, Tx, Rx)
Case: PC with captive mounting hardware
Screw Terminal Block: Accepts 0.5 mm 2 to 2.5 mm 2 , 1 - #12 or
2 - #14 to #22 AWG
NOTE: Equipment will operate below 30% humidity,
however, static electricity problems occur much
more frequently at lower humidity levels. Make
sure you take adequate precautions when you
touch the equipment. Consider using ground
straps, anti-static floor coverings, etc. if you use
the equipment in low humidity environments.