User manual

Chapter 6
Planning Y our Application Pr ogram
System Design Flow Chart
Select I/O Module
Select Power Supply
Select Link Terminal & Cable
Select Operator Interface
Selecting Your
Hardware Component
System Hardware Configuration
Install Utility Software
I/O Module Configuration
Network Setting
I/O Module Calibration
System Configuration
Guide
Determine Proper Environment
Install Main Unit and Module
System Mounting
Hardware Installation
Guide
Security Setting
Terminal Emulation
UDP Data Stream
Modbus Data Gateway
Wiring and Connecting
I/O Address Mapping
Using ADAM-5000/TCP Series
DLL Driver
Planning Your
Application Program
Individual I/O Module
Introduction
I/O Modules
Introduction
Using ADAM-5000/TCP
Series Command Set
Appendix
Relational Document &
Technical Information
Using this Chapter
If you want to read about Go to page
DLL Driver 6-2
Programming Flow6-4
Programming Flow 6-32
Command Structure 6-33
Modbus Function Code Introduction 6-39
Apply with ASCII Command 6-40
- System Command Set 6-48
- Analog Input Command Set 6-127
- Analog Output Command Set 6-140