User Manual

Utility Software
D-
6 ADAM 4000 Series User’s Manual
D.2 The procedure for ADAM-4000 series installation guide
When user fi rst t ime get s AD AM-4000 modules, he c an re fer f ollowing
procedure t o c onfigure a nd operate. Es pecially not e t hat new ADAM-4000
modules will have de fault factory settin gs with Address setting 1, a nd data
format 9600, N, 8, 1. Redefine the address to avoid ID conflict if two or
more new modules are used in the same network.
Standard Installation Procedures
1. Prepare the install environment
• Host computer
• Isolated RS-232/RS-485 Converter
• AD AM module
2. Install ADAM-4000-5000 utility in host computer
3. Wiring for ADAM-4000 module
Power supply & Communication Wiring
4. Move hardware switch to Initial mode (For some older Adam models,
use an external wire to connect the INIT* terminal to the GND
terminal. Booting the module wh ile co nnecting the INIT* terminal with
the m odule’s GND t erminal fo rces t he c onfiguration i nto a k nown st ate
called the INIT* state.)