User Manual

Chapter 4
Chapter 4 Command Set 4-11
ADAM-4015/ADAM-4015T Command Table
Command
Syntax
Command Name
Command Description
Page
No.
%AANNTTCCFF
Configuration
Sets the address, baud rate, data format,
checksum status, and/or integration time for a
specified analog input module
5
-
4
$AA2
Configuration Status
Returns the configuration parameters for the
specified analog input module
5
-
10
$AAF
Read Firmware
Version
Return the firmware version code from the
specified analog input module
5
-
12
$AAM
Read Module Name
Return the module name from the specified
analog input module
5
-
13
#AA
Analog Data In
Returns the input value from a specified analog
input module in the currently configured data
format
5
-
14
#AAN
Read Analog Input
from Channel N
Returns the input value from a specified channel
of analog input module in the currently configured
data format
5
-
16
$AA5VV
Enable/Disable
Channels for
Multiplexing
Enable or disable the individual channels in an
analog module
5
-
17
$AA6
R
ead Channel
Status
Get the enable/disable status of all channels in
an analog module
5
-
18
#**
Synchronized
Sampling
Orders all analog input modules to sample their
input values and store them in special registers
5
-
21
$AA4
Read Synchronized
Data
R
eturns the value that was stored in the specified
module's register after the #** command
5
-
22
$AAB
Channel Diagnose
Diagnose channel status in over range, under
range, and wire opening
5
-
24
$AA0Ci
Single Channel
Span Calibration
Calibrates a speci
fied channel to correct for gain
errors
5
-
27
$AA1Ci
Single Channel
Offset Calibration
Calibrates a specified channel to correct for offset
errors
5
-
28
$AA7CiRrr
Single Channel
Range Configuration
Configure the input type and range of the
specified channel in an analog input module
5
-
29
$AA8Ci
Read Single
Channel Range
Configuration
Get the input type and range of the specified
channel in an analog input module
5
-
30
$AAXnnnn
Watchdog Timer
Setting
Set communication
WDT
cycle
time from 0000 ~
9999 (unit: 0.1 second. if value is 0000, the
communication WDT function will be disable)
5
-
31
$AAY
Read Watchdog
Timer Setting
Read the
cycle time
setting of communication
WDT
5
-
32
$AAS0
Internal Calibration
Internal self
-
calibration for offset and
gain errors
5
-
33
$AAS1
Reload default
calibrating
parameter
Reload factory default calibrating parameter to
overwrite current calibrating parameter
5
-
34