User Manual

Chapter 4
Chapter 4 Command Set 4-25
ADAM-4024 Command Table
Comman
d Syntax
Command Name
Command Description
Page
No.
%AANNTTCCFF
Configuration
Set the address, output range,
baud rate, data format, slew rate
and/or checksum status
6
-
19
#AA
Cn
(data)
Analog Data Out
Directs output data to a specified
module
6
-
20
#AASCn(data) Set Startup Data Set data As CHn StartUp Data
6
-
20
#AAECn(data) Set Emergency
Stop
Set data As CHn Emergency
Stop Data
6
-
20
#** N/A Synchrous Sample IDI
6
-
20
$AA0
Cn
4 mA Calibration
Tells the module to store
parameters for 4 mA Calibration
6
-
20
$AA1
Cn
20 mA Calibration
Tells the module to store
parameters for 20 mA Calibration
6
-
20
$AA2
Configuration
Status
Read
back Module status
6
-
20
$AA3
Cn
(number of
counts)
Trim Calibration
Trims specified module a number
of units up/down
6
-
20
$AA4
Sta
rt
-
up output
current/voltage
configuration
Stores a default output value in a
specified module. The output
value will take effect upon startup.
6
-
20
$AA5
Reset Status
Read Back Reset Times After Last
$AA5 CMD And Clear This ounter
6
-
20
$AA6
Cn
Last Value
Readback
Returns either last value sent to
specified module by #AA
command, or start-up output
current/voltage
6
-
20
$AA7CnRxx
Set Output Type
Set CHn Output Type
6
-
20
$AA8
Cn
Current Readback
Returns measured value of the
current/voltage flowing through
current loop
6
-
21
$AAF
Read Firmware
Version
Return the firmware version code
from the specified analog output
module
6
-
21
$AAM
Read Module
Name
Return the module name from the
specified analog output module
6
-
21
(Continued on following page)