User manual

11 Chapter 2
2.3 Installing Riser Card and Add-on Card
ACP-2010MB supports up to 3 add-on cards. To install the add-on card,
please install a riser card first. The process is as follows:
1. Insert the riser card on the motherboard. Then, attach it onto the
beam on the chassis by fastening the two screws. (see Figure 2.5)
2. Remove the corresponding I/O bracket attached to the rear plate of
the chassis. Insert an add-on card vertically into the proper slot on
the riser card. For full-length cards, please make sure that the card
bracket has been inserted properly and the other edge of the card
has been inserted into the plastic guiding fillister. Then fasten the
screws on the top of the I/O bracket. (see Figure 2.6)
3. Repeat Step 2 if there is more than one add-on card to be installed.
Figure 2.5: Installing the riser card
Figure 2.6: Installing the add-on card
Note: If the chassis with the low profile I/O bracket on
the rear plate is used, a riser card is not needed.