Use and Care Manual

10
INSTALLATION
Fig 21
Fig 23 Fig 24
Fig 26
Fig 22
Fig 25
www.advaning.com
Clean the pilot hole
and remove excess
dust/debris with a
vacuum. Insert an ex-
pansion bolt set into
each hole ( a hammer
may be used).
Leave the hex bolt
head outside of the
hole.
Using a socket wrench
tighten the hex bolt,
this will cause the
anchor/wedge to
expand and lock the
sleeve in place.
Unscrew and remove
the hex bolt. Ensuring
the sleeve and
anchor/wedge are
locked within the
wall.
Place the wall bracket
over the holes and
use a level to make
sure the bracket is
straight.
Re-insert the hex bolt
with washer through
bracket and into the
xed sleeve.
Tighten the hex bolts
to secure wall bracket
to surface.
Masonry Installation detailed photos and tips available via www.advaning.com
Tighten
Socket
wrench
Bracket
Level
Expansion bolt set
Hex bolt
Hex bolt
Tighten bolt head
Leave hex bolt
head outside
Wall
Wall
Wall
Wall
Bracket
6
7
8
9
10
11
12
6
7
8
9
10
11
12