Owner's Manual

7
Fig 10
Fig 11
Fig 12
INSTALLATION
ASSEMBLE THE
DOOR AWNING
Peel the protective
lm from both the
top and bottom back
about 2” from the
front and the wall side
edges of the awning
sheet.
Apply the rubber
strips to the front and
wall side edge of the
awning sheet.
Trim off all excess
rubber strips.
Press the awning bars
onto the front and
wall side edges of the
awning sheet.
Using a small wooden
block and a rubber
hammer, gently tap
along the entire
length of the awning
bars to rmly secure
the bars to the
awning sheet
www.advaning.com Toll Free (US): [phone]
NOTE: Polycarbonate
protective lm is labeled
with an arrow, showing
which side goes up
and which side of the
polycarbonate goes
against the wall.
THIS SIDE UP
1
2
3
4
4
4
5
5
1
2
2
3