HD-1000V2
GENERAL/概述 INTRODUCTION SCOPE OF THIS MANUAL 引言 本手册的范围 This manual is intended for use by experienced technicians familiar with similar types of commercial grade communications equipment. It contains all required service information for the equipment and is current as of the publication date.Changes which may occur after publication are covered by either Service Bulletins or Manual Revisions. These are issued as required.
SAFETYTRAINING INFORMATION Your radio generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as “Occupational Use Only”, meaning it must be used only during the course of employment by individuals aware of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by the “General Population” in an uncontrolled environment. This radio has been tested and complies with the FCC RF exposure limits for “Occupational Use Only”.
ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body when transmitting and only use the belt-clip which is listed in instructions when attaching the radio to your belt, etc., to ensure FCC RF exposure compliance requirements are not exceeded. To provide the recipients of your transmission the best sound quality, hold the antenna at least 5 cm (2 inches) from your mouth, and slightly off to one side.
OPERATING NOTES When transmitting with a portable radio, hold the radio in a vertical position with its microphone 5 to 10 cm (2 to 4 inches) away from your mouth. Keep the antenna at least 2.5 cm (1 inch) from your head and body. If you wear a portable two-way radio on your body, ensure that the antenna is at least 2.5 centimeters (1 inch) from your body when transmitting.
910
MODES 模式 USER MODE MODES PC MODE PC模式 用户模式 FUNCTION 模式类型 User mode For normal use.
DISASSEMBLY FOR REPAIR/维修时拆卸部分 Separating the case assembly from the chassis 1. Remove the knob 1 and the round nut 2 2. Remove the six screws 3 and 4 3. Expand the right and left sides of the bottom of the case assembly, lift the chassis,and remove it from the case assembly 5. 4. Taking care not to cut the speaker lead 7,open the chassis and case assembly. Separating the chassis from the unit Remove the screws 8 and drop-out line, and lift the first unit off. 从底座上分离外壳 1.取下旋扭 1 和环形螺母 2 2.取下六颗螺钉 3 和 4 3.
FCC ID: Q9SHD-1000V2 IC: 4651A-HD1000V2 NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
