ABH-400 Bluetooth Headset Manual ADVANCED WIRELESS COMMUNICATION 1 User Manual
SAFETY INFORMATION WARNING! Permanent hearing loss may result from long-term exposure to sound at high volumes. Use as low a volume as possible. Headsets are capable of delivering sounds at loud volumes and high pitched tones. Under certain circumstances, exposure to such sounds can result in permanent hearing loss damage. The volume level may vary based on conditions such as the phone you are using, its reception and volume settings, and the environment.
Built-in battery care: Your product is powered by a rechargeable battery. The full performance of a new battery is achieved only after two or three complete charge and discharge cycles. The battery can be charged and discharged hundreds of times, but will eventually wear out. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time.
FCC: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference. Any changes or modifications not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
COMMON PACKAGE ITEMS Part 1 Number 221126 2 Item Qty.
Headset View： 1. Battery charging port 2. LED Indicator 3. Key1: Power switch 4. Key2: Volume adjustment /Music selection 5. Key3: Talk button/ Answer, Reject, Hang up 6. Key4: Language switching/Music Play, Pause Wearing the Headset： If you need to wear the headset to your other ear, you can rotation the earplug to the opposite side, and then adjust the microphone pole to a suitable position. See the following figure.
Charging the Bluetooth Headset The battery must be fully charged before your first use! Charging temperature is 0~40℃. 1. 5V DC /100mA Power supply would be the best choice. 2. Plug the USB cable into the 6 gang charger power port. 3. When charging the headset, the LED indicator shows red. When charging finished, the red turns to blue. 4. To charge the headset at least once a month even you do not use it usually. ON/OFF 1.
4. Now you can enjoy your radio with your Bluetooth headset. Receive a Call When the radio receives a call, you will hear the voice in you Bluetooth headset directly. Adjust the headset volume 1. Slide Key2 to – direction and hold to decrease the volume 2. Slide Key2 to + direction and hold to increase the volume Make a Call In standby mode, click the key3 twice to make a call, the radio will enter transmit state. Click Key3 again to end the call. The radio will enter receive mode.
Adjust the headset volume 1. Slide Key2 to – direction and hold to decrease the volume. 2. Slide Key2 to + direction and hold to increase the volume. Hung up the phone Click key3 to hung up. Reject the call When there is an incoming call, press key3 for 1 second to reject the call. The last call redialing In standby mode, to click the key3 twice to redial the last number dialed.
20809 Kensington Blvd., Lakeville, MN 55044-8353 (800) 475-5852 www.advancedwireless.com ©2016 Advanced Wireless Communications. All rights reserved.
