Service Manual

17
Setting
No.
(PTT)
Function
name
Settings
(Defaults are
underlined)
Display
([UP]/
[DOWN])
Specifications
9
Time Out
timer
(TOT)
0
1-10
6
OFF
30-300
180
OFF: 10 minutes
(Step: 30s)
ON
ON ON: Beep is on.
10
Beep
OFF OFF OFF: Beep is off.
ON ON ONBacklight is enabled.
11
Backlight
OFF OFF OFF: backlight is disabled.
Wideband
25 2525.0KHz
12
Wideban-
d/Narrow
-band
Narrowband 1250 1250: 12.5KHz
ON
ON
13
Battery
save
OFF OFF
Wired clone
First enable Wired Clone Mode in dealer mode. (Refer to “Dealer Mode” in page 5).
Turn on the radio while holding down [MONI], in 2 seconds, LCD displays“clone”; Release [MONI],
the radio enters wired clone mode.
(1) Press PTT to enable/disable Wired Clone Mode of the cloned radio. The Wired Clone Mode
settings of the original radio will not be changed.
Pressing PTT button, the green LED flashes two times with a beep to enable Wired Clone Mode;
the red LED flashes two times with two beeps to disable.
Entering Wired Clone Mode, the default is disabling the Wired Clone Mode of the cloned radio.
(2) Press [MONI], LCD displays “-C-“, clone begins and “c” blinks at the same time; after clone
completes, blink stops, and LCD displays “-c-End”.
Blink