Service Manual

16
Function set
Select “FUNSEt” in Power On Menu. The radio enters function set mode.
Setting
No.
(PTT)
Function
name
Settings
(Defaults are
underlined)
Display
([UP]/
[DOWN])
Specifications
OFF OFF Monitor function is OFF
Monitor
Momentary
1 Hold down [MONI] to cut off signaling temporarily.
Monitor Lock 2 Press [MONI] to cut off signaling. Switches each time
[MONI] is pressed.
1 Monitor
SQ
OFF
Momentary
3 Hold down [MONI] to open squelch.
Carrier
operated
CO
2
Scan
Time operated TO
3
Dropout
Time
0.5-5s
5s
0.5-5
5
Time until scan restarts when it’s stopped by
transmission. Step: 0.5s
OFF OFF No priority channel
Fixed 1 Fixed priority channel
4
Priority
setting
Selectable 2 Selectable priority channel
5
Priority
channel
1-N (2-99)
1
1-N Valid only when the fixed priority channel is set.
6
Look
Back
0.5-5s
(Step: 0.5s)
1.5s
0.5-5.0 The period priority channel is checked while scan
stops at a non-priority channel during priority scan.
Last call 1 Last channel at pause in scan. Channel where scan is
stopped. Channel at start of scan when scan not
stopped at all.
Last used 2 Last channel transmitted during scan.
Channel where scan is stopped. Channel at start o
f
scan when scan not stopped at all.
Scan start 3 Channel where scan started during scan.
Channel where scan is stopped.
7
Revert
channel
select
Priority 4 Priority channel during scan. Channel where scan is
stopped.
8
Squelch
level
0-9
5
0-9
5