Service Manual

(2) dEL: delete the channel from scan list, and the channel (except priority channel) will not be

scanned.

7. Press [PTT], LCD displays “HI”/“LO”. Press [UP]/[DOWN] to toggle RF power between high

and low. LCD displays as follows:

8. Press [PTT], LCD displays “BSy On”/“BSyOFF”. Press [UP]/[DOWN] to toggle Busy Channel

Lockout between ON and OFF.

9. Press [PTT] to save settings. Press [PTT] again to enter the next channel and continue the settings.

When settings are completed, turn off power to exit.

Model set and reset

Short out the two SELF points on PCB, and turn on the power. After a “beep” sounds, (red LED

glows at the same time), LCD displays all signs. And then the two SELF points is released, the radio

enters model set and reset mode, LCD displays BAND 1-22 and red LED goes out.

. Press [up]/[down] to select model number 1-22. (Data of initialization is as the following

table)

. Press [PTT] to confirm selected model and then reset.