User Manual

Trilogue-1NM
User Manual V1.4
Advanced RF Technologies, Inc. Proprietary Document Page 31 of 43
3.4.3 Location
Please type in the location information (Latitude & Longitude) where the
repeater is installed. If there are no location information with latitude and
longitude, any heartbeat will not be sent out to NOC (Network Operation
Center).
3.4.4 Static IP/ Dynamic IP
Will display the Repeater’s Static IP Address, Subnet Mask, and Gateway.
This information is necessary when using the Repeater in conjunction with the
External Modem Box (MBOX-DET1). Default values are:
Repeater IP: 192.168.63.5
Subnet Mask: 255.255.255.0
Gateway: 192.168.63.254
3.4.5 Repeater
There are two Repeater
Install buttons for CDMA and iDEN, respectively.
Please click the
Install button to automatically setup the repeater on both
Install windows.
It may take up to 3 minutes to complete the CDMA(or iDEN) install. You
will see a gradual progress bar display. After the process is completed, a pop-
up window will display “Installation Successfully Completed” messa
ge.
C
lick on
Status window, the Installation box now changes from “Not
Installed
” to “Installed.”
If the Trilogue-1NM detects a problem during the installation process, it will
show a prompt message, e.g., “Low RSSI.” Please follow the instructions and
address the problem to finish the installation process.
If the problem persists, please contact our technical support.
3.4.6 Repeater Location
Please type in the physical address where the repeater is installed.
3.4.7 Repeater Installer Info
Please type in the installer’s name, phone number and e-mail address for
technical support.
3.4.8 Date & Time
Sets the date and time for the internal clock (required for Log Messages)