User Manual

Trilogue-1NM
User Manual V1.4
Advanced RF Technologies, Inc. Proprietary Document Page 29 of 43
3.4.1 Band Selection
Simply click on the desired operating bandwidth. The selected band will be
highlighted in blue. To deselect, click again on the undesired band. The
deselected band will turn back gray. Please see below Band Selection screen
shot.
3.4.1.1 CDMA Band Selection
The CDMA subsystem of the Trilogue-1NM has three (3) independent RF
paths:
Path 1 supports 5 MHz bandwidth;
Path 2 supports 5 or 10 MHz bandwidths; and
Path 3 supports 5 or 15 MHz bandwidths.
One can use only one Path (single band: Path 1, Path 2 or Path 3), any of the
two Paths (Two contiguous or non-contiguous sub-bands: Path 1 and Path 2,
Path 2 and Path 3, Path 1 and Path 3), or all three Paths (Three contiguous or
non-contiguous sub-bands: Path1, Path 2 and Path 3). Therefore, the
instantaneous bandwidths that the Trilogue-1NM support are 5, 10, 15, 20, 25
or 30 MHz.
The following Band Selection shows that A1 (5 MHz) is selected in Path 1,
A3+D (10 MHz) is selected in Path 2, and the entire B band (15 MHz) is
selected in Path 3. With this setting, Trilogue-1NM amplifies A1+A3+B
bands.