User Manual

Trilogue-1NM
User Manual V1.4
Advanced RF Technologies, Inc. Proprietary Document Page 14 of 43
2.3 Installation
2.3.1 Tools
No special tools or equipments are needed to install the Trilogue-1NM
2.3.2 Procedure
Six mounting holes are located on the wall-mounting bracket to attach it to the
wall. The wall bracket must be securely attached to sufficiently carry the
weight of the Trilogue-1NM, which is bolted to the wall bracket through the
four aligned mounting holes.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Take the Trilogue-1NM out of the box
② Using the four anchor bolts, mount the bracket on the wall
③ Make sure the bracket is securely mounted
④ Slightly tilt the repeater and mount the repeater onto the wall as shown in
the picture. Hook the upper 2 guard screws first and then slide/push in
the lower 2 guard screws into the place.
⑤ Make sure the Trilogue-1NM is securely placed onto the wall bracket
⑥ Fasten the 8 bracket screws back properly
⑦ Inspect that everything is secure
* Rack Mount option is also available. Please contact ADRF for additional
information.