User Manual

Trilogue-1NM
User Manual V1.4
Advanced RF Technologies, Inc. Proprietary Document Page 11 of 43
2. Trilogue-1NM Overview
2.1 Operation Modes
2.1.1 Local Web GUI
Host Mode
This mode should be selected only if a Trilogue-1NM is used alone without
being connected to any other device functioning as a host.
Simply connect one end of the Ethernet cable on the repeater monitor port and
the other end on the PC’s LAN port. After doing so, launch the Microsoft
Internet Browser (Internet Explorer) and the Local Web GUI will be launched
through typing the IP address (
http://192.168.63.1/home.asp
)
2.1.1. Remote Web GUI
Remote Mode
This mode should be selected if an external modem box (MBOX-DET1) is
being installed along with the Trilogue-1NM
for monitoring purposes. In this
case, the Trilogue-1NM works as a remote unit sending its information to the
collocated external modem box.
Note: ADRF’s Web GUI has not been developed for Microsoft Internet Explorer and other
web browsers (e.g. Netscape, FireFox, Mozilla, etc.) may not be compatible. ADRF’s Web
GUI has not been tested with Microsoft Internet Explorer versions higher than 6.0.