User Manual

Epoch-S02-8002W RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 14 of 33
11. Go to the Install Window
Now with the blinking TX and RX status LEDs on the Status Window, go to
the Install Window. You will see the following:
12. Select the Desired Band or Bands
Select the desired band or bands by clicking the appropriate buttons.
** If a wireless modem is not connected, skip steps 13 through 15 and
proceed to step 16.
13. Provide SNMP Information
Type in the Site ID and the Manager IP address as given to you by the
Wireless Provider. Once both the parameters are typed in, you must click
“Set” for it to be executed.
14. Check the Modem Connection
Verify that the
Auto Connection box is checked and then click on
“Connect.”
15. Click on Install
After the first three steps, click on “Install.” This installation process will
normally take less than 5 minutes.
** Please refer to the “Quick Installation Guide” for any questions or
problems that you may encounter during this installation process.
Figure 4 - Installation Window of the Epoch-S02 OMS V1.XX