User Manual

Epoch-S02-8002W RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 12 of 33
4. Connect the Power Source and Ground Wire
Make sure that the power switch inside the repeater is turned off before
connecting the power cable. Connect the power cable to the power
source as shown in Figure 3 (# 3). Connect the ground wire (GNDSTD01)
to the ground connector as shown in Figure 3 (# 5).
** Before connecting the power cable to the power source, make sure that
the voltage source is 110 V.
5. Connect the Donor Antenna
Connect one end of the RF coaxial cable to the donor antenna and the
other end to the repeater donor port located on the bottom of the Epoch-
S02-8002W as shown in Figure 3 (# 2).
6. Connect the Server Antenna
Connect one end of the RF coaxial cable to the server antenna and
connect the other end to the repeater server port located on the bottom
of the Epoch-S02-8002W as shown in Figure 3 (# 4).
7. Connect the Serial Cable
Using the straight-through serial cable (included in the box), connect one
end of the cable to the Epoch-S02-8002W’s NMS port located on the
bottom of the repeater (# 1 - Figure 3) and the other end to the laptop’s
serial port.
Figure 3 – Bottom Side of the Repeater
# 1 - NMS Port
# 2 - Donor
Antenna Port
# 4 - Server
Antenna Port
# 5 - Ground Port
# 3 - AC Power Supply