User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 9 of 33
1.3 Tools and Recommendations for Installation
The following may be necessary (not required) for installation of the repeater:
a. Crescent Wrench
b. Philips Screw Driver
c. Lift, Ladder, or Boom Truck
d. Spectrum Analyzer
e. Sweep Tester
f. Signal Generator
g. Pilot Scanner
h. RF Power Meter
i. Voltmeter
j. Coaxial Cables
k. Compass
l. PC with an RS-232 serial port (with Epoch-S02 OMS V4.XX Software installed)
The list above may vary depending on if brackets are used to install the repeater.
Bring additional tools that may be useful during installation. It is recommended
that two people install the Epoch-S02-1900 repeater system.
1.4 Epoch-S02-19002W Parts List
The Epoch-S02-19002W repeater system includes:
PART ID
QUANTITY
a. Epoch-S02-19002W Repeater EPOCHSO201 1
b. Repeater I-Bracket (Added Option) ISRB01 1
c. Nuts and Bolts BLTS01 4
d. Screws (Added Option) SC01 8
e. Epoch-S02 OMS V4.XX SO2OMS V4.XX01 1
f. Ground Cable GNDSTD01 1
g. Straight-Through Serial Cable SCST01 1
h. Keys KEYS01 4
1.5 Epoch-S02 OMS V4.XX Installation and Requirements
1.5.1 Minimum Requirements
Hardware (PC Platform)
CPU: 200 MHz
Memory: 32 MB