User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 11 of 33
1.6 Pre-Installation using Epoch-S02 OMS V4.XX
Prior to the Epoch-S02-1900 installation, ensure that:
a. The correct COM port is selected.
b. The donor and server antennas are in place.
c. The TX and RX communication status LEDs are blinking.
** The TX and RX LEDs should blink every 1 second only in the Status
Window. In the Status Window, a blinking green RX LED indicates that the
PC is retrieving data from the repeater (Epoch-S02-1900). Similarly, a
blinking green TX LED indicates that the PC is transmitting data to the
Epoch-S02-1900.
** If neither of the LEDs is blinking: (1) check the COM port setting of
your PC by choosing the port to which the serial port is assigned; (2)
check the straight-through serial cable is connected properly between
the PC and the repeater; or (3) check if the repeater power is on.
1.7 Step by Step Instructions for Installation
1.7.1 Repeater Setup
1. Mount the I-Bracket (Optional)
Position the I-Bracket (ISRB01) at the desired location. Using the 8
screws (SC01) provided, fasten the I-Bracket securely.
2. Attach Repeater to the I-Bracket (Optional)
Using the 4 bolts (BLTS01) provided, fasten the repeater (Epoch-S02-
19002W) to the I-Bracket.
3. Open the Epoch-S02-19002W
Open the front door of the repeater cabinet by using the key (KEYS01)
provided. There are two locks integrated into the door latches. One key
works for both locks.
** Please keep the cabinet door open fully during the installation until
you are instructed to close the cabinet.