User's Manual

Epoch-III-C9024/9030/9533
User Manual V0.1
Advanced RF Technologies, Inc. Proprietary Document Page 21 of 36
3.2 Repeater Status
If you click on Status tab, the following window will appear:
In this window, the user can view the following:
(To change any parameters, e.g., Instantaneous Band Width, Gain Settings, AGC
Level, etc., you must go to the Install or the Control window.)
By clicking the CDMA button, the user can check the status of the CDMA
subsystem. The CDMA button turns black gray.
- CDMA Band: Will display the center frequencies of the 800 MHz spectrums
on the downlink and uplink respectively.
- Power & Gain(CDMA): Will display the repeater input, gain and output
power on the downlink and uplink.