User's Manual

Epoch-H (HP/HC) RF Repeater
User Manual V1.5
Advanced RF Technologies, Inc. Proprietary Document Page 42 of 60
v) If the steps above do not remedy the situation and you still cannot connect to
the Web GUI, then follow these steps:
a. Verify that the switch is set to Host
b. Switch the network adapter back to “Obtain IP Address Automatically”,
which can be done by going to the Start Menu ->Control Panel ->
Double-click Network Connections ->Right-click Local Area
Connection ->Left-click Properties ->Scroll down to the bottom of the
list ->Double-click Internet Protocol ->Select “Obtain an IP address
automatically”-> click OK
c. Power down the repeater and wait at least 10 seconds
d. Power down the laptop and wait at least 10 seconds
e. Verify that a cross-over network cable is connected to the unit and
laptop
f. Power up the repeater and wait 30 seconds
g. Power up your laptop
h. Launch Internet Explorer and in the address bar input
http://192.168.63.1/