User's Manual

Advanced RF Technologies, Inc. Proprietary Document Page 40 of 60
5. Epoch-H Series Troubleshooting Guide
5.1 Connectivity Guide for LAN
∴ If you cannot connect to the Web GUI, please follow the steps listed below:
i) If you see the icon below (Figure 16)
Figure-16
- Check the Power Line to see whether or not the repeater is being powered correctly.
- Use the Cross-over Cable that came with the repeater to connect the repeater to your
laptop. If you still cannot connect, replace the cross-over cable with another one.
- If unsuccessful, power the repeater down and wait for at least 5-10 seconds for it to
electrically discharge, then power the repeater back up. Wait for the PWR LED to light
up before attempting the IP address in browser again. (When the repeater powers up, you
will hear a faint click)
ii) If you see the icon in Figure 17, then the computer is in the process of
obtaining an IP Address and you will not be able to connect to the unit. Once you see the
icon in Figure 18 then you can attempt to connect to the unit.
Figure-17
Figure-18
- If unsuccessful: Go to Start ->Control Panel or Start ->Settings ->Control Panel.
Double-Click
Network Connections-> Right-Click Local Area Connection ->Left-Click
Properties ->Scroll down to the bottom of the list ->Double-Click Internet Protocol
(TCP/IP)