User's Manual

Epoch-H (HP/HC) RF Repeater
User Manual V1.5
Advanced RF Technologies, Inc. Proprietary Document Page 27 of 60
- Cellular Band: Will display the center frequencies of the 800 MHz spectrums
on the downlink and uplink respectively.
- Power & Gain: Will display the repeater input, gain and output power on the
downlink and uplink.
- Alarm: Will display seven alarms with three different status conditions
(Normal, Soft Fail or Hard Fail). Door Open: Soft fail alarm
- Message Board: Will show up to recent 20 log messages (Alarms &
Heartbeats).
- Installation: Will display repeater’s installation status (Not Installed or
Installed).
- Repeater Info: Will display repeater’s serial number, and location
information (latitude and longitude coordinates).
- Repeater Location: Will display the address where the repeater is installed
- Technical Support: Will display ADRF’s technical support contact
information.
- Installer Contact Info: Will display the installer’s name, phone and e-mail
address.
- Modem (only applicable if a wireless modem is connected to the repeater)
The Auto Connection box needs to be checked when the wireless modem is
installed inside the repeater. A wireless modem is used in order to send the
alarms and the heartbeat over the air to the Wireless Provider’s NOC.
Note: Once successfully logged in, the repeater model name and the site/cascade
ID will be displayed on the top of all the windows.