User's Manual

Epoch-H (HP/HC) RF Repeater
User Manual V1.5
Advanced RF Technologies, Inc. Proprietary Document Page 18 of 60
2.1.6 Other Ports
- Donor Antenna Port
Connect Donor Antenna.
- Donor CPL Port
You can check Donor output power.
- Sever Antenna Port
Connect Sever Antenna.
- Server CPL Port
You can check Donor output power.
2.2 Installation
2.2.1 Tools
No special tools or equipments are needed to install the Epoch-H
2.2.2 Procedure
Eight mounting holes are located on the wall-mounting bracket to attach it to
the wall. The wall bracket must be securely attached to sufficiently carry the
weight of the Epoch-H, which is bolted to the wall bracket through the four
aligned mounting holes.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Take the Epoch-H out of the box
② Using the six anchor bolts, mount the bracket on the wall
③ Make sure the bracket is securely mounted
④ Slightly tilt the repeater and mount the repeater onto the wall as shown in
the picture. Hook the upper 2 guard screws first and then slide/push in
the lower 2 guard screws into place.
⑤ Make sure the Epoch-H is securely placed onto the wall bracket
⑥ Fasten the 8 bracket screws back properly
⑦ Inspect that everything is secure