User Manual

Epoch-HP RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 24 of 36
Band
Select the desired band or bands by clicking on “Band Selection.” Once
you do so, the following window will come up:
You can select any 5 or 15 MHz block or any 5 MHz and 15 MHz
contiguous blocks at anytime.
** If a wireless modem is not connected to the repeater, simply select the
desired operating band(s) and click on “Install.”
SNMP
(only applicable if a wireless modem is connected to the repeater)
a. Site ID
The
Site ID is a unique ID for each site and will be provided by the
Wireless Provider.
b. Manager IP
The
Manager IP address will be provided by the Wireless Provider. The
repeater will send alarms to the Wireless Provider’s NOC to the assigned
Manager IP address.
Modem
(only applicable if a wireless modem is connected to the repeater)
The
Auto Connection box needs to be checked when the wireless modem
is installed inside the repeater. A wireless modem is used in order to
send the alarms and the heartbeat over the air to the Wireless Provider’s
NOC.
Repeater
Click the “Install” button and the repeater will setup automatically.
For information regarding the use of the Epoch-H V1.X during installation, refer
to Section 2.7.1 on page 12, “Repeater Installation” (starting at number 8).
Figure 12 – Band Selection Window of the Epoch-H V1.X