User Manual

Epoch-HP RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 15 of 36
10. Select the Desired Band or Bands
Select the desired band or bands by clicking on “Band Selection.” Once
you do so, the following window will come up:
You can select any 5 or 15 MHz block or any 5 MHz and 15 MHz
contiguous blocks at anytime.
** The above band configuration strictly depends on which model you are
using (e.g. S1, S2, or S3). Please refer to Table 1 on Page 5.
** If a wireless modem is not connected, skip steps 11 through 13 and
proceed to step 16.
11. Provide SNMP Information
Type in the Site ID and the Manager IP address as given to you by the
Wireless Provider. Once both the parameters are typed in, you must click
“Set” for it to be executed.
12. Check the Modem Connection
Figure 4 - Installation Window of the Epoch-H V1.X
Figure 5 – Band Selection Window of the Epoch-H V1.X