User Manual

Epoch-HP RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 12 of 36
2.5.2 Epoch-H V1.X Installation
Installing the Epoch-H V1.X
a. Insert the CD into the CD-ROM drive.
b. Click on “My Computer.”
c. In the “My Computer” window, click on your CD-ROM drive (usually
labeled D:).
d. Double-click the file labeled “Epoch-H V1.x.exe.”
e. The installation wizard will guide you through the conclusion of the
Epoch-H V1.X installation process.
2.5.3 Initial Startup of Epoch-H V1.X
a. Using the USB cable (USB01) that is provided, connect one end of the
cable to the PC USB port and the other end to the repeater’s USB port
located on the bottom of the repeater.
b. Open the Epoch-H V1.X software
2.7 Pre-Installation using Epoch-H V1.X
Prior to the Epoch-HP installation, ensure that:
a. The USB driver is installed and the USB cable is connected at both
ends.
b. The donor and server antennas are in place.
c. The TX and RX communication status LEDs are blinking.
** The TX and RX LEDs should blink every 1 second only in the Status
Window. In the Status Window, a blinking green RX LED indicates that the
PC is retrieving data from the repeater (Epoch-HP). Similarly, a blinking
green TX LED indicates that the PC is transmitting data to the Epoch-HP.
** If neither of the LEDs is blinking: (1) check if the USB deriver has been
installed; (2) check the USB cable is connected properly between the PC
and the repeater; or (3) check if the repeater power is on.
2.8 Step by Step Instructions for Installation
2.8.1 Repeater Setup