User Manual

7 8
After 5 seconds the Delos will exit from Band
Selection Mode. At this time the Delos will
cycle information regarding the downlink and
uplink signals.
Make sure these numbers are accurate and
stable.
54
6
Plug in the power converter.
Turn on the Delos.
The Delos will start extending RF coverage
as soon as you power it on.
(110VAC Adapter) Press and hold the VFD button as shown in
figure 5 to enter “Band Mode.”
By pressing the Power button you will
change the bandwidth to either 5, 10, or
15MHz.
By pressing the Alarm button you will
increment the band accordingly.
POWER BAND SELECTION MODE SELECT BAND/CHANNEL
DOWNLINK/UPLINK POST SURVEY
Congratulations! The Delos has been
successfully installed and is ready for use.
It is recommended to do a walk-through
inside of the building and make live phone
calls to verify RF coverage.
132
The box should contain:
1 - Delos Series Repeater
1 - CD (Software and User Guide)
1 - USB Cable
1 - AC/DC Power Adapter
1 - Quick Install Guide Sheet
Locate the place where you will put the
Delos. You can hang the Delos or put it on
anything. In any case, make sure the Delos
is securely fastened to a wall or any
structure so that it won’t move.
Connect the donor/server antenna cables to
the Delos’s antenna ports on top as shown in
figure 3.
Adjust antenna positioning to assure
maximum coverage.
REPEATER PLACEMENT ANTENNA CONNECTIONOPEN THE BOX
Documentation and Software can be found on the CD-ROM
included in the Delos box.
Technical Support
Contact ADRF’s Technical Support Team for assistance with:
-Software Questions
-Setting up the Delos
-Delos Operation
-Troubleshooting Questions
Delos200 Quick Start Guide
www.adrftech.com
1-323-254-8131
1-800-313-9345