User Manual

Delos200 RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 18 of 30
Downlink/Uplink HPA Mode
The HPA mode enables the user to turn the HPA on or off. If the HPA is turned
off on either link, the Delos200 will not operate properly. Both HPAs needs to be
turned on for the RF portion of the repeater to work in both directions (downlink
and uplink). By default, the
Downlink/Uplink HPA ON box are checked.
Either or both HPAs can be turned off for troubleshooting purposes during an
installation process.
Downlink/Uplink Gain
The gain of the Delos200 is the ratio of the input signal to the output signal.
The gain may be set in both links.
** The manual gain option is disabled when the AGC ON box is checked.
Reboot
By clicking the “Reboot” button, similar to how the operation works in a PC, the
control board of the repeater will restart itself.
Factory Setting
Clicking on the “Factory Setting”
button resets the settings of the repeater to the
original default factory settings as noted in the “Default Control Settings” in
Section 2.4 on page 28.
** You will lose your current saved settings once you click on Factory Setting.