User Manual

Delos200 RF Repeater

User Manual V1.1

Advanced RF Technologies, Inc. Proprietary Document Page 17 of 30

2.1.3 Control Menu

The Control Window lets the user to change parameters of the repeater.

Band Selection

Depending on which model of the Delos200 you have, you can choose the

desired filter from the drop down menu by clicking on

and the corresponding

band options can be viewed by clicking on

Band

. Please refer to Table 2 on page

12 for all the possible band combinations.

AGC Mode

AGC (Auto Gain Control) adjusts the variable gain of the repeater to ensure a

constant specified output power of 23 dBm. The functionality of the AGC feature

is assured under the condition that the input BTS signal is within the specified

AGC range (-57 to -32 dBm => assuming AGC Level is set to 23 dBm) and that

sufficient isolation exists between antennas (≥ 93 dB). By default, the

AGC ON

box is checked. To manually change the gains in both the links,

AGC ON

must

be unchecked.

The user can specify the AGC level in the downlink and in the uplink respectively

@ 0.5 dB step (0 to 23 dBm). By default, the AGC Level is set to 23 dBm in each

link.

Figure 6 - Control Window of the Delos200 Software