User Manual

Delos200 RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 13 of 30
7. Go to the Control Menu
Now with the blinking TX and RX status LEDs on the Status Window, go to
the Control Window. You will see the following:
8. Select the Desired Band(s)
In the Band Selection section of the Control Window (Figure 3), click on
the pull down arrows labeled “BW” and “Band.”
You can choose your desired bandwidth (5, 10 or 15 MHz) by clicking on
the pull down arrow labeled “BW.” After selecting your desired filter, click
on the pull down arrow labeled
Band and choose your desired operating
band.
The following table illustrates the three bandwidths you can choose from
and the corresponding bands which can be selected:
Bandwidth Band Options
5 MHz A1, A2, A3, D, B1, B2, B3,
E, F, C3, C4 or C5
10 MHz A1+A2, A2+A3, A3+D, D+B1, B1+B2,
B2+B3, B3+E, E+F, F+C3, C3+C4
or C4+C5
15 MHz A1+A2+A3, A3+D+B1, B1+B2+B3,
B3+E+F, F+C3+C4 or C3+C4+C5
Figure 3 - Control Window of the Delos200 Software
Table 2 – Band Combinations