User Manual

Delos200 RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 12 of 30
2. Connect the Donor Antenna
Connect one end of the RF coaxial cable to the donor antenna and the
other end to the repeater Donor Antenna Port located on the top of the
Delos200 as shown in Figure 2.
3. Connect the Server Antenna
Connect one end of the RF coaxial cable to the server antenna and
connect the other end to the repeater Server Antenna Port located on the
top of the Delos200 as shown in Figure 2.
4. Connect the USB Cable
Using the USB cable (included in the box), connect one end of the cable to
the Delos200’s USB port located on the right side of the repeater and the
other end to the PC’s USB port as shown in Figure 2.
** Install the USB driver and the Delos200 Manager Software prior to
installation.
5. Turn On the Power for Delos200
Make sure that the donor and server antennas and the power cable are
securely connected to the correct ports. Turn the power switch on,
located on the right side of the repeater.
6. Launch the Delos200 Software
Open the Delos200 Software. You will see the Status Menu.
** For more detailed information on the Delos200 Software, please refer
to Section 2 on page 15.
** If only one or both of the LEDs on the Status Window are not blinking:
(1) check the physical USB cable connection or (2) check if the repeater
power is turned on.