User's Manual
Table Of Contents
- 1. Introduction
- 2. Overview
- 3. Alarms
- 4. Installation
- 5. AXM2100-9543-ICS Web-GUI Setup
- 6. Maintenance Guide for AXM2100-9543-ICS Repeater
- 7. Warranty and Repair Policy
- 8. Specifications
- 9. mechanical drawing
- 10. Appendix
The SNMP section allows you to specify the Site ID and Manager IP. The Site-ID is the code that is used to
identify a particular module. The Manager IP field is where the user inputs the IP address of the NOC system that
is being used to monitor the SNMP traps.
5.4.3 Location
This section allows the user to input the latitude and the longitude of the repeater.
Figure 5-20 Location Setting
5.4.4 Modem Box Settings
This section allows the user to specify an alternative Repeater IP, Subnet Mask, and Gateway settings. These
settings are enabled when the Host/Remote switch is set to the Remote position. When the Host/Remote switch
is changed, the repeater will reboot and will result in a temporary loss in coverage.
Figure 5-21 Modem Box Setting
5.4.5 Auto Installation
Figure 5-22 Auto Installation
The Auto Installation routine can be run by clicking on the Install button. The Auto Installation routine runs
basic system checks to ensure proper functionality.
Advanced RF Technologies, Inc. 34