User's Manual

Axiom Repeater
User Manual V0.3
Page | 26
4. Axiom Web-GUI Setup
The Web-GUI allows the user to communicate with the repeater either locally or remotely. To
connect to the repeater locally, you will need a laptop with an Ethernet port and a RJ-45
crossover cable. To connect to the repeater remotely, you will need to have an active internet
connection and the repeater must have either an internal modem or an Omnibox (ADRF Modem
Box) connected to the repeater.
4.1 Repeater/PC Connection Using Web-GUI
A. Verify that your Local Area Connection is set to Obtain an IP address automatically
under the Internet Protocol (TCP/IP) properties
 If you are connecting to the unit remotely, then skip steps A and B.
B. Connect the RJ-45 crossover cable between the laptop’s Ethernet port and the
repeater’s Ethernet port
C. Launch Microsoft Internet Explorer (Version 7.0 or below)
D. Type the following IP address into the address bar of Microsoft Internet Explorer:
http://192.168.63.1
 If you are connecting to the unit remotely, then type the IP address of the modem to
connect to the unit
E. The following login screen will appear:
If you are not the Administrator, please type in your assigned username & password
which you should have received from the Administrator.
The default username and password for the General User is adrf & adrf, respectively.
If the username & password is typed in incorrectly, the following screen will appear: