User's Manual

Axiom Repeater
User Manual V0.3
Page | 20
3.4 Power supply architecture
Figure 13: Power supply architecture
3.5 Installation
3.5.1 Procedure
Eight mounting holes are located on 4 corners of repeater to attach it to the 19”
rack. The repeater must be securely attached to a rack mount system that can
sufficiently carry the weight of the Axiom.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Verify that the repeater and mounting hole are in good condition.
② Align the repeater to the mounting holes of the rack mount system.
③ Screw the repeater to the rack using 8 mounting screws.
④ Make sure the Repeater is securely attached.
⑤ Connect the GND cable.
⑥ Connect the Antenna cable.
⑦ Connect the Power.
⑧ Using a laptop, install the Repeater.