User's Manual

AEON-9030 RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 29 of 51
AGC Mode
AGC (Auto Gain Control) adjusts the variable gain of the repeater on both
downlink and uplink to ensure a constant specified output power. The
functionality of the AGC feature is assured under the condition that the input BTS
signal is within the specified AGC range and that sufficient isolation exists
between antennas. By default, the AGC ON box is not checked. To change the
AGC levels on the Uplink and Downlink, AGC ON must be checked.
ⓑ Manual Gain Control
- Downlink Gain Control (60 to 90 dB @ 0.5 dB step)
- Uplink Gain Control (60 to 90 dB @ 0.5 dB step)
- Downlink AGC Level
AEON-9030: 10 to 30dBm @ 0.5 dB step, default value: 30dBm
- Uplink AGC Level
AEON-9030: 10 to 30dBm @ 0.5 dB step, default value: 30dBm
ⓒ System
- If you click the Reboot button, the following message box will appear:
When a system reboot is performed, no settings are changed, but coverage is
temporarily lost.
Please wait approximately 30 seconds to 1 minute for the system to reboot.