User's Manual

AEON-9030 RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 17 of 51
2.2 Installation
2.2.1 Tools
No special tools or equipments are needed to install the AEON-9030.
2.2.2 Procedure
The wall-mounting bracket has six mounting holes which are used to mount
the bracket to the wall. The wall bracket must be securely attached to the wall
in order to support the weight of the AEON-9030. After mounting the bracket
to the wall, the AEON-9030 is placed on the mounting bracket using the four
guard screws attached to the AEON-9030.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Take the AEON-9030 out of the box.
② Using the six anchor bolts, mount the bracket on the wall.
③ Make sure the bracket is securely mounted.
④ Slightly tilt the top portion of the repeater and mount the repeater onto the
wall as shown in the picture on page 18. Hook the upper 2 guard screws
first and then slide/push in the lower 2 guard screws into place.
⑤ Make sure the AEON-9030 is securely placed onto the wall bracket.
⑥ Fasten the 8 bracket screws back properly on both sides.
⑦ Verify that the repeater is secure and properly grounded.