User's Manual

AEON-9030 RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 16 of 51
2.1.4 Ethernet Port
Figure 11 shows the Ethernet port which is used to interface with the unit via
RJ-45 crossover cable. Verify that the Host/Remote switch is set to Host and
set your network adapter to “Obtain an IP Address Automatically” and the
repeater will assign an IP Address via DHCP. The Host/Remote switch
should only be set to Remote when an external modem box is being used to
monitor the unit.
Figure 11: Ethernet Port
2.1.5 Modem Module
Figure 12 shows the Modem Module that is used to remotely interface with
the unit via modem. The modem will allow for remote configuration and
monitoring via SNMP.
Figure 12: Modem Module
2.1.6 Other Ports
- Donor Antenna Port
Port where the Donor Antenna will be connected.
- Sever Antenna Port
Port where the Server Antenna will be connected.