User's Manual
6(59(5 &3/
x Server Port
- Connected to Server Antenna or RU channel combiner (ADX-R-CHC).
x CPL Port
- 30dB coupling port of Server port.
()'/,1()'/287()8/,1()8/287
x Can be connected to the DL/UL external filter
x DL external filter can be used to reduce DL out-band emissions
x UL external filter can be used to reduce out-band frequenies
)LJXUH3RUWVDWWKHEDFNSDQHO0DVWHU58
2 SWLF3RUW
x Connets to ADX-H-OPT via optic line
3RZHU2Q2II6ZLWFK'&,13RUW
x Power On/Off switch
- Master RU Power On/Off switch
x DC IN Port
- Connected to DC output port of AC/DC adaptor (ADX-R-ADP-30) or RU PSU (ADX-R-PSU-30)
3 68$ODUP3RUW
x Connected to the ADX-R-PSU-30
x NMS & master RU can monitor the status of RU PSU via this port
* 8,3RUW
x Connects to a laptop via USB cable
x Monitor/control the RU and the HE connected to the RU using User GUI, which is a Windows
based program. ADRF 32-bit or 64-bit drivers will also be required to access the RU using the User
GUI.
5 63RUW
x Slave RU should be connected to master RU in a diasy chain structure using RS-485 line to
monitor and control slave RUs.
x The RS-485 cable connected to master RU should be connected to RS-485 IN port of slave RU.
When a slave RU is connected to another slave RU, then the RS-485 cable should be connected
from the RS-485 OUT port to the RS-485 IN of the 2
nd
Slave RU. (Figure 3-36)
x If RS-485 port connections between sub RUs are not correct, master RU will not be able to
recognize all subordinate slave RUs. (Figure 3-37)
x WARNING! The RS-485 ports should NEVER be connected to the Enthernet port of laptop
or Ethernet Network Equipment. Doing so may cause serious damage to the sub RUs or
network equipments. (Figure 3-38)