User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
Frequency Change
Frequency Change
CHANNEL
SELECTION MODE
Hold the
VFD
Button
for 5 sec
CHANNEL UP
150 to 175
Push the
ALARM
Button
Push the
ALARM
Button
10 sec
10 sec or
Hold the
VFD Button
for 5 Sec
POWER VFD ALARM
(Green) (off)
POWER VFD ALARM
(off)
CHANNEL UP
175 to 200
10 sec
POWER VFD ALARM
(off)
POWER VFD ALARM
(off)
(Green)
(Green)
(Green)
Advanced RF Technologies, Inc. Proprietary Document Page 38 of 38