User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
Hard Fail Alarm Operation
Hard Alarm Operation
HARD FAIL ALARM
VSWR
SYSTEM
HALT
HARD FAIL ALARM
CLEARED
20 min
SYSTEM
ALARM CHECKING
Power Off
Initializing....
POWER VFD ALARM
6 sec
16 sec
Booting Time
Power On
(off) (off)
POWER VFD ALARM
(Green) (Red)
Display Cycle*
POWER VFD ALARM
(Green) (off)
POWER VFD ALARM
(Green) (Red)
POWER VFD ALARM
(Green) (off)
POWER VFD ALARM
(Green) (Red)
POWER VFD ALARM
(Green) (Red)
4 sec
4 sec
Alarm
Cleared?
Yes
No
If the VFD button
is clicked, the
display will be
come up again.
POWER VFD ALARM
(Green) (off)
The VFD display
will be disappeared
30 minutes later
since the VFD
button is touched.
Right away
Advanced RF Technologies, Inc. Proprietary Document Page 37 of 38